Choose between red or gol parts thrusters
The references that change depending if we choose red or gold colour are:
7, 8, 9,13,14, 15 and 16
metal parts contents:
1, Vulcan 2 ---------------- [1.3mm] drill
2, metal eyes a glue stick on ---------------- []
3, large neck screw a 1.0mm drill ----------- []
4, chest vents 2 ------------- [1.5mm] drill
5, metal shoulder stab three ------------- [3.5mm] drill
6, shoulder vents 6 ------------- [1.5mm] drill
7, led astray shoulder screw 2 -------- [3.5mm] drill
8, neck tube 10 --------- power drill [1.0mm]
9, waist power tube 16 --------- [3.0mm] drill
10, hand joint screw ring 8 ----- [glue stick]
11, leg joints screw ring 8 ----- [glue glue]
12, backpacks spout 3 ------------ [2.0mm] drill
13, inner thigh vents 2 ------- [2.0mm] drill
14, heel spout 2 ------------ [2.0mm] drill
15, outer thigh vents 2 ------- [2.0mm] drill
16, lateral leg vents 2 ------- [2.0mm] drill
17, foot spout 2 ------------ [1.5mm] drill
18, knee hydraulic pipe 4 ------- [2.8 and 1.0mm drill]
19, the front leg 2 with hydraulic ------- [2.2 and 1.0mm drill]
20, heel hydraulic pipe 4 ------- [2.2 and 1.0mm drill]
21, arm aeration holes 12 -------- [2.5mm] drill
22, metal details screw 30 ------ [2.0mm] drill
23, metal beads 50 ------------- [1.5mm] drill
Total metal-parts: 231
PS. The metal kit installation requires some experience and model transformation tools, more of the glue used in 502 or UFO, high quality, you understand. ʱ?? ʱ?? ʱ??
■ installation tools required to:
Hand drill, drill (1.0mm, 1.3mm, 1.5mm, 2.0mm, 2.2mm, 2.8mm, 3.0mm, 3.5mm), glue (502 or UFO and other all-purpose adhesive), metal cutting pliers (cheap, specifically cut the kind of metal)
■ metal mounting method:
1, on the model parts corresponding drill hole size. (Such as the need to install 1.5mm metal screws, then drill holes of 1.5mm.)
2. Use the reamer (or larger diameter drill) in the wall of the hole to produce a certain amount of chamfer.
3, using tweezers combine good metal parts have been opened into a good hole to complete the installation.
4, if the part is loose, you can use a toothpick dipped a little 502 glue, applied to the pore walls, until the glue is completely dry, and then squeezed the metal parts which can be fixed on the model parts.
■ Note:
1, the installation of this set of metal parts need to have some experience in modeling transformation. If you do not understand the place to contact customer service, we will be happy to serve you on production.
2, the part of small, easily lost, the installation requires special attention.
